Click on sections of the label to learn more about it.
NFPA 70E recommends identifying those situations in which there is a hazard to the worker. A commonly used guideline is to use “Warning” below 600V or “Danger” in red over 600V or when the incident energy is over 40 cals/cm2.
Shows the specific hazard and appropriate steps to take.
When working within the shown distance, this is the estimated incident energy that a worker would be exposed to in the event of an arc flash. This is the incident energy level used to determine PPE ensemble rating.
Distance from an exposed live part at which an unprotected worker would likely receive a second-degree burn in the event of an arc flash. Both qualified and unqualified workers may cross the Arc Flash Boundary as long as they are wearing proper arc flash PPE, as specified in NFPA 70E. Unqualified persons must be escorted by a qualified person to cross this boundary.
This is the voltage that a worker would be exposed to if shocked.
Distance from an exposed live part at which a shock hazard exists. Both qualified and unqualified workers may cross the Limited Approach Boundary as long as they are wearing proper shock hazard PPE, as specified in NFPA 70E. Unqualified persons must be escorted by a qualified person to cross this boundary.
Distance from an exposed live part at which there is an increased risk of shock from arc-over or inadvertent movement. Unqualified workers may not cross this boundary. Qualified workers must wear PPE appropriate to the voltage they are exposed to, as specified in NFPA 70E. At a minimum some form of documentation is required to cross this boundary, often an approved work permit is required.
ASTM Glove Classes are 00, 0, 1, 2, 3, 4, which correspond to increasing voltage applications.
This indicates PPE category from NFPA 70E that is required to perform work on this equipment. In the case of older labels (like this 2012 label), PPE categories and requirements should always be considered in light of the latest requirements and PPE updates.
This is an old term that was removed in NFPA 70E (2015). It was a shock hazard boundary that has now been incorporated into the Restricted Approach Boundary.